Uniform Wind

The wind is constant in time and in the horizontal direction. If no vertical wind shear is applied, the wind is also constant in the vertical direction, making it constant in time and space. A vertical shear following a power law can be applied, see Wind profile power law.
 

Speed and angle

Wind speed

The (horizontal) wind speed at the reference point. The reference point is typically the hub.

If there is no wind shear then this is the wind speed everywhere. For Uniform wind, neither the wind speed nor the wind angle can change during the simulation.

  • Default value: 10
  • Unit: ${\text{m}} \over {\text{s}}$
  • Range: -100 — 100

Wind angle

The angle (direction) of the wind in the horizontal plane relative to North. Clockwise is positive. 0° means that the wind is coming from the North. 90° means that the wind is coming from the East.

For Uniform wind, neither the wind speed nor the wind angle can change during the simulation.

  • Default value: 0
  • Unit: $°$
  • Range: -360 — 360

Shear profile

Shear

Decides if a shear law is applied to the deterministic wind.


  • Default value: False
  • Unit:

Power law exponent

The shear is computed using a power law. This is the power law exponent.

To see how the power law is computed, see Wind profile power law

  • Default value: 0.2
  • Unit:
  • Range: 0 — 100

Reference height scheme

This parameter lets your define whether the point of application of the reference speed (used to compute a vertical wind shear) is input by you or defined as the hub height. This parameter is only relevant if a shear law is applied to the wind. 

IHub height is selected, the reference wind speed for the shear will be applied at hub height. If the turbine has multiple rotors, the reference wind speed will be applied at the average hub height. If there is no rotor, the reference speed is applied at the average height of the nodes at sea level. 

Options:

Hub height (default):

The reference height is set to the hub height.

User defined:

The reference height is set explicitly by the user (you).

Reference height

The height above the ground (or above sea level for offshore turbine) where the reference wind speed is applied.

Hub height is often used for the reference height, but in some cases it is convenient to use another height. E.g. if the wind speed is given for a height of 10 m above ground, then this parameter should be set to 10 m. Note: The reference height only has an influence if there is shear (see Wind profile power law)

  • Default value: 10
  • Unit: $\text{m}$
  • Range: 0.01 — 1000